Modelling pastes for watercolours

 

AQUA modelling paste, fine

for structures with even surfaces

50706

Modelling paste for watercolours. Achieves white, relief-like, fine painting grounds on e.g. paper (> 350 g/m²), cardboard or wood. Apply on surfaces with spatula; dries to a water-resistant film which is allowed to be overpainted with water-colours after being dried; the pure modelling paste may also be tinted with tube water-colour or acrylic colour.

Thinner: Water

Handling

    • Stir – if necessary – before use.
    • AQUA modelling paste, fine is ready to use and should be applied pure with a pallet knife onto the painting ground. (If coats thicker than 1 cm are required, these should be built in stages!)
    • Can be overpainted with water-colours after getting completely dry. (The time for drying depends on the thickness of the surface and can last from several minutes up to several hours!)
    • The pure product may also be tinted with tube water-colour or acrylic colour. (Always use a separate palette for mixing – the product may never be put directly into the pans!)
    • The product is water mixable, but dries up water-insoluble.
    • Please clean working tools as soon as possible with water or water and soap.
    • Please don´t use the product below temperatures under 10 °C object- and room-temperatures.
    • Close immediately after use.
    • Store in a cool and dry place.
    • Protect from frost.
    • Individual pre-tests are required.

                         

                        Sizes: 125 ml and 300 ml

                        Contains: pure acrylate dispersion, fillers, additives.

                        Signal word:

                        Hazard statements
                         

                        Safety precautions

                        Other hazards
                        May produce an allergic reaction.